A study on performance of PVC/MWCNTs nanocomposite membranes in humic acid solution filtration

Document Type : Research paper

Authors

1 Department of Chemical Engineering, University of Mohaghegh Ardabili, Ardabil, Iran.

2 Department of Chemical Engineering, Faculty of Engineering, University of Mohaghegh Ardabili , Ardabil, Iran

3 Faculty of Chemical Engineering, Sahand University of Technology, Tabriz, Iran

Abstract

In this research, the effect of multiwall carbon nanotubes (MWCNTs) on the performance of polyvinyl chloride (PVC) membrane in the filtration of humic acid solution was investigated. The FESEM results showed that the number of surface pores in nanocomposite membranes is more than that of PVC membrane. The tensile strength and abrasion resistance of membranes increased with increasing MWCNTs up to 0.3 wt.%. It was also observed that water flux of membrane containing 0.3 wt.% MWCNTs increases up to 484.7 L/m2h. The decrease of water contact angle from 88.6° for PVC membrane to 70.2° for 0.3 wt.% MWCNTs membrane showed that the hydrophilicity of membranes increases with increasing MWCNTs. It was also found that the rejection of humic acid solution with MWCNTs membranes is more than that of PVC membrane. The analysis of fouling mechanism of membranes revealed that the cake formation model is dominant mechanism for all membranes and cake filtration-complete blockage model fits the volume-time data.

Keywords

Main Subjects

References

[1] J. Mulder (2012) Basic principles of membrane technology, Springer Science & Business Media.
##
[2] M. Sancho, J. Arnal, G. Verdú, J. Lora and J. Villaescusa (2006) "Ultrafiltration and reverse osmosis performance in the treatment of radioimmunoassay liquid wastes", Desalination, 201, 207-215.
##
[3] K.C. Khulbe, C. Feng and T. Matsuura (2008) Synthetic polymeric membranes: characterization by atomic force microscopy, Springer Science & Business Media.
##
[4] A. Rahimpour, S. Madaeni, A. Taheri and Y. Mansourpanah (2008) "Coupling TiO2 nanoparticles with UV irradiation for modification of polyethersulfone ultrafiltration membranes", Journal of Membrane Science, 313, 158-169.
##
[5] S.B. Teli, S. Molina, E.G. Calvo, A.E. Lozano and J. de Abajz (2012) "Preparation, characterization and antifouling property of polyethersulfone–PANI/PMA ultrafiltration membranes", Desalination, 299, 113-122.
##
[6] F.C. Chiu (2014) "Comparisons of phase morphology and physical properties of PVDF nanocomposites filled with organoclay and/or multi-walled carbon nanotubes", Materials Chemistry and Physics, 143, 681-692.
##
[7] P. Daraei, S.S. Madaeni, N. Ghaemi, H.A. Monfared and M.A. Khadivi (2013) "Fabrication of PES nanofiltration membrane by simultaneous use of multi-walled carbon nanotube and surface graft polymerization method: comparison of MWCNT and PAA modified MWCNT", Separation and Purification Technology, 104, 32-44.
##
[8] Y. Zhao, Z. Xu, M. Shan, C. Min, B. Zhou, Y. Li, B. Li, L. Liu and X. Qian (2013) "Effect of graphite oxide and multi-walled carbon nanotubes on the microstructure and performance of PVDF membranes", Separation and Purification Technology, 103, 78-83.
##
[9] Z. Rahimi, A. Zinatizadeh and S. Zinadini (2015) "Preparation of high antibiofouling amino functionalized MWCNTs/PES nanocomposite ultrafiltration membrane for application in membrane bioreactor", Journal of Industrial and Engineering Chemistry, 29, 366-374.
##
[10] A. Behboudi, Y. Jafarzadeh and R. Yegani (2016) "Preparation and characterization of TiO2 embedded PVC ultrafiltration membranes", Chemical Engineering Research and Design, 114, 96-107.
##
[11] H. Rabiee and V. Vatanpour (2015) "M.H.D.A. Farahani, H. Zarrabi, Improvement in flux and antifouling properties of PVC ultrafiltration membranes by incorporation of zinc oxide (ZnO) nanoparticles", Separation and Purification Technology, 156, 299-310.
##
[12] A. Behboudi, Y. Jafarzadeh and R. Yegani (2017) "Polyvinyl chloride/polycarbonate blend ultrafiltration membranes for water treatment", Journal of Membrane Science, 534, 18-24.
##
[13] G. Bolton, D. LaCasse and R. Kuriyel (2006) "Combined models of membrane fouling: development and application to microfiltration and ultrafiltration of biological fluids", Journal of Membrane Science, 277, 75-84.
##
[14] E. Demirel, B. Zhang, M. Papakyriakou, S. Xia and Y. Chen (2017) "Fe2O3 nanocomposite PVC membrane with enhanced properties and separation performance", Journal of Membrane Science, 529, 170-184.
##
[15] Y. Jafarzadeh, R. Yegani (2015) "Thermal, mechanical, and structural properties of ZnO/polyethylene membranes made by thermally induced phase separation method", Journal of Applied Polymer Science, 132 (30).
##
[16] J. Dasgupta, S. Chakraborty, J. Sikder, R. Kumar, D. Pal, S. Curcio and E. Drioli (2014) "The effects of thermally stable titanium silicon oxide nanoparticles on structure and performance of cellulose acetate ultrafiltration membranes", Separation and Purification Technology, 133, 55-68.
##
[17] J. Ji, S. Zhou, C.Y. Lai, B. Wang and K. Li (2015) "PVDF/palygorskite composite ultrafiltration membranes with enhanced abrasion resistance and flux", Journal of Membrane Science, 495, 91-100.
##
[18] C.Y. Lai, A. Groth, S. Gray  and M. Duke (2014) "Preparation and characterization of poly (vinylidene fluoride)/nanoclay nanocomposite flat sheet membranes for abrasion resistance" , Water research, 57, 56-66.
##
[19] G. Arthanareeswaran, T.S. Devi and M. Raajenthiren (2008) "Effect of silica particles on cellulose acetate blend ultrafiltration membranes: Part I" , Separation and Purification Technology, 64, 38-47.
##
Journal of Separation Science and Engineering
Volume 11, Issue 1
July 2019
Pages 13-25

Files

Share

How to cite

Statistics