Modeling of simultaneous removal of carbon dioxide and hydrogen sulfide in a polypropylene hollow fiber membrane contactor in the presence of monoethanolamine

Document Type : Research paper

Author

Graduate from MS Shiraz Petrochemical Engineer

Abstract

In this paper, a two-dimensional mathematical model was presented for the removal of CO2 and H2S in a polypropylene hollow fiber membrane contactor in the presence of MEA. Modeling was performed in both axial and radial directions under the dry condition for countercurrent gas-liquid flow arrangement. To evaluate the model, the results of this modeling were compared with experimental data of removal of CO2 in the presence of water physical solvent and MEA chemical solvent. The results showed that the CO2 and H2S removal efficiency increased with the increase of the liquid flow rate, number of fibers, membrane length, and solvent concentration, but, decrease by increasing gas flow rate because of lower hold up time.  It was also found that in low amine discharges, hydrogen sulfide is completely removed. Finally, the results showed that by increasing the wetting, the removal of these gases is reduced.

Keywords

Main Subjects


1] A. Gabelman, and S.T. Hwang, "Hollow fiber membrane contactors." Journal of Membrane Science, 159(1), pp. 61-106, 1999.
 
 [2] D.L.V. Katz, "Handbook of natural gas engineering." McGraw-Hill, 1959.
 
[3]M. Stewart
[1] A. Gabelman, and S.T. Hwang, "Hollow fiber membrane contactors." Journal of Membrane Science, 159(1), pp. 61-106, 1999.
 
 
 
 [2] D.L.V. Katz, "Handbook of natural gas engineering." McGraw-Hill, 1959.
 
 
 
[3]M. Stewart and K. Arnold, "Gas sweetening and processing field manual: part 1, Gas Sweetening"pages 87-92, 2011
 
DOI:10.1016/B978-1-85617-982- 9.00002-8
 
 
 
[4] R.E. Treybal, "Mass transfer operations." New York, 1980.
 
 
 
[5] C.J. Geankoplis, "Transport processes and separation process principles:(includes unit operations). " Prentice Hall Professional Technical Reference, 2003.
 
 
 
[6] G. Srikanth, "Technology and business opportunities."  Water Conditioning & Purification, 2008.
 
 
 
[7] R. Baker, "Membrane technology in the chemical industry: Future directions." "Membrane Technology: in the Chemical Industry, pp. 268-295, 2001.
 
 
 
[8] J.D. Seader,E,J. Henley, and D.K. Roper, D.K., Separation process principles. 1998.
 
 
 
[9] S. Adhikari, and S. Fernando, "Hydrogen membrane separation techniques." Industrial & Engineering Chemistry Research, 45(3), pp. 875-881, 2006.
 
 
 
[10] Z. Qi, and E. Cussler, "Microporous hollow fibers for gas absorption: I. Mass transfer in the liquid." Journal of membrane science, 23(3), pp. 321-332, 1985.
 
 
 
[11] Z. Qi, and E. Cussler, "Microporous hollow fibers for gas absorption: Ii. Mass transfer across the membrane." Journal of Membrane Science, 23(3), pp. 333-345, 1985.
 
 
 
 [12]        H. Kreulen, C. Smolders, G. Versteeg,  and W.P.M. Van Swaaij,  "Microporous hollow fibre membrane modules as gas-liquid contactors. Part 1. Physical mass transfer processes: A specific application: Mass transfer in highly viscous liquids." Journal of Membrane Science, 78(3), pp. 197-216, 1993.
 
 
 
[13]         H. Kreulen, C. Smolders, G. Versteeg,  and W.P.M.Van Swaaij, "Microporous  hollow fibre membrane modules as gas-liquid contactors part 2. Mass transfer with
 
chemical reaction." Journal of Membrane Science, 78(3), pp. 217-238, 1993.
 
 
 
[14]         R. Wang, H. Zhang, P. Feron, and  D. Liang, "Influence of membrane wetting on CO2 capture in microporous hollow fiber  membrane contactors." Separation and Purification Technology, 46(1), pp. 33-40,  2005.
 
 
 
 [15] M. Al-Marzouqi, M. El-Naas, S.Marzouk, and N. Abdullatif, "Modeling of chemical absorption of co 2 in membrane contactors."Separation and Purification  Technology, 62(3), pp. 499-506, 2008.
 
 
 
[16]         P. Keshavarz, J. Fathikalajahi, and S. Ayatollahi, "Analysis of co2 separation and simulation of a partially wetted hollow fiber membrane contactor."Journal of  Hazardous Materials, 152(3), pp. 1237-1247, 2008.
 
 
 
[17] S. Rajabzadeh, S. Yoshimoto, M. Teramoto, M. Al-Marzouqi, and  H. Matsuyama, H., "CO2 absorption by
 
using pvdf hollow fiber membrane contactors
 
 with various membrane structures." Separation and Purification Technology, 69(2), pp. 210-220, 2009.
 
 
 
[18] M.R. Sohrabi, A. Marjani, S. Moradi,  M. Davallo, and S. Shirazian, S., "Mathematical modeling and numerical simulation of CO2 transport through hollow-fiber membranes."Applied Mathematical Modelling, 35(1), pp. 174-188, 2011.
 
 
 
[19] A. Golkhar, P. Keshavarz, P., and D. Mowla, "Investigation of co 2 removal by silica and cnt nanofluids in microporous hollow fiber membrane contactors." Journal of membrane science, 433, pp. 17-24, 2013.
 
 
 
[20] S. Masoumi, P. Keshavarz, and Z. Rastgoo, "Theoretical investigation on co 2 absorption into deab solution using hollow fiber membrane contactors." Journal of Natural Gas Science and Engineering, 18, pp. 23-30, 2014.
 
 
[21] R. Faiz, and M. Al-Marzouqi,
 
"Mathematical modeling for the simultaneous absorption of co 2 and h 2 s using mea in hollow fiber membrane contactors." Journal of Membrane Science, 342(1), pp. 269-278, 2009.
 
 
 
[22] E.L. Cussler, " Diffusion: Mass transfer in fluid systems." Cambridge university press, 2009.
 
 
 
[23] S. Paul, A.K. Ghoshal, and B. Mandal,  "Removal of co2 by single and blended aqueous alkanolamine solvents in hollow-fiber membrane contactor: Modeling and simulation." Industrial & engineering chemistry research, 46(8), pp. 2576-2588, 2007.
 
 
 
[24] R.B. Bird, W.E. Stewart, and E.N. Lightfoot, "Transport phenomena."John Wiley & Sons, 2007
 
 
 
[25] H.Y. Zhang, R. Wang, D.T. Liang, and J.H. Tay, "Modeling and experimental study of co 2 absorption in a hollow fiber membrane contactor." Journal of membrane science, 279(1), pp. 301-310, 2006.
 
 
[26] S. Karoor, and K.K. Sirkar, "Gas absorption studies in microporous hollow fiber membrane modules."Industrial & engineering chemistry research, 32(4), pp. 674-684, 1993.
and K. Arnold, "Gas sweetening and processing field manual: part 1, Gas Sweetening"pages 87-92, 2011